Cleaning the Keyboard and Mouse:

Before you hook the case back up to all the cables, lets clean the Keyboard and mouse. First take the can of compressed air and spray the Keys of the Keyboard, also turn it upside down to let any bigger objects fall out. You can pop each Key off from the Keyboard with a flat screw driver to clean under them, just remember where they go, lol. I also use one of those Anti-Static Wipes for cleaning these.


Next take a damp paper towel and wipe off the pads on the bottom of your mouse and the mouse's body, do not wipe off the optical light, just blow that off, sometimes a piece of lint will get stuck in front of that light and then the mouse will act crazy. If you have an Optical Mouse and it is acting weird check to make sure nothing is blocking the light and the batteries are good.

If you have the ball type mouse, remove the ball by turning the retainer ring that is around the ball, then remove the rubber ball.

Then take a cotton swab and clean off the three plastic rollers that the ball rests on in the mouse body. These get lint built up on them from the rubber ball and makes the mouse act slow and weird. If you dip the swab in some alcohol, then take it and run it across the face of the roller. Then you may be able to take a tweezers and grab the lint and pull it off, you'll be amazed at how much lint is on the rollers, lol.

Next put some alcohol on a cloth and clean the rubber ball, then dry it. Once you are done cleaning, put the ball back in and then the ring, then twist the ring to lock it into positio

Picture of the reassembled mouse.